Mitutoyo 3-Wire Thread Holder and Wire Set, 1.25mm – 64AAA267

Features

• Fast and accurate method of thread measuring available for use with Micrometer

Applications

• Measure set of thread plug gages and working thread plug gages.
  
• Monitor the wear on working thread plug gages.
  
• Monitor and control pitch diameter variation during thread fabrication.
  
• Reduce measurement time to a fraction of the time normally taken using the traditional three wire method.
  
• Use in conjunction with go/no-go thread ring gages to control thread size to the most demanding specifications.
  
• Determine out of roundness and taper that may exist in threaded parts.
  
• Applications for preplating and post plating thread measurement.

Tolerance of Wires:

• Diameter +/- .000010
• Roundness +/- .000010
• Surface finish 2 micro inches AA, lapped
• Hardness HRC 59-64
• Certification of accuracy included
• Traceable to NIST
• Meets or exceeds all ANSI and ISO specs

See all Mitutoyo 3-Wire Thread Measuring System Sets